Method one: suspend the rod; for example, when the second and third quarters are stuck, move the fishing rod apart, take out the second, third and fifth quarters, and then turn a towel on the wooden floor, leading the second and third quarters to the fifth quarter. It is to open the rod block and throw the rod section of the rod out by gravity; many new anglers like this action to prove the role of the rod and vibrate smoothly, but old anglers No one did this. Method three: blow with a hair dryer; when the pole section is opened, muddy water seeps out from the inner wall of the fishing rod, mostly because the sand penetrates into the anti-locking area of ​​the pole section. Method two, apply oil; if method fishing swivel snap one fails, you can find some sewing machine oil, which is sold in general hardware stores. 

There is muddy water in the joint, and the joint may be stuck. Layer paper, burn the side of the white paper, and only tin foil is left; wrap the stuck part of the pole section with tinfoil, then the hottest setting of the hair dryer, blow it on for 3~5 minutes, and then use the pole section to heat it , Find two pieces of rubber, hold the pole joints on both sides, and twist them in the opposite direction to open them. The biggest difference between the vibrating rod and the continuous fishing rod is here; the vibrating rod uses the different element diameter and first diameter of the rod joint (that is, the upper and lower ends of the rod joint) to place the thinner rod joint It can save space in the thicker pole section, which is an excellent advantage; however, the upper and lower top positions of the pole section are treated with frosted anti-locking treatment, which is to avoid the intersection of the fishing rods, and the friction is too large. 

Method four: rod retractor; this is suitable for one, two and three knots stuck, the pole section is a little thicker, it is not suitable, the specific method of use is also very simple, tighten the middle part of the two pieces of rubber next to the stuck pole section , And then twist it in the opposite direction, which is especially useful for one or two knots; but if the pylon that has not been maintained for a long time is twisted like this, it will basically be broken, so use it with caution. 

Don’t worry if this happens. Pour a little oil along the stuck pole joint interface, pour it evenly on a circle, and then put it on After one night, if you use method one, you can basically stop. Generally, you can open the dead knot after a dozen or so of pauses

Hide Comments | Add Comment